What We Had Been Doing In Technology

Planning and Research:

Our teacher first showed us this video then we got given a piece of paper each with three rectangles, one on top already had the measurement and both are blank. First, we had to find the middle, in order to do that we drew a line across both sides of the wood and one in the middle.









Drawing:
We drew from corner to corner and middle of the wood horizontally and vertically.


Transferring you paper plan on to the timber:
 After measuring on the paper we did it on the timber. We drew lines from corner to corner of the wood then drew a line in the middle in order to find the very middle of the wood and drew a circle on it. After doing that we used one side of the block wood (the shorter side) and placed it on the line and trace it, for the uppercase and lowercase t we measured 6cm on both sides of the wood and drew a line from the bottom to the minus sign and for the uppercase I went a little bit over the minus sign.

How did you make it?

1.  Draw your plan on a paper and measure it.
2. Draw your measurement on your 3 pieces of wood. (one with a minus sign, one with upper case T and lowercase t)
3. Drill holes into the piece of wood with the minus sign on it.
4. Chisel the remaining wood.
5. File it to make it smooth.
6.  Cut out both the capital and lowercase T on the radial saw.
7. (make sure all your wood fit).
8. File it to make it smooth.
9. Put it all together.